Cutting and bending tool for pressure ring

For a customer who manufactures hot water boilers, we have developed and produced a new tool to replace an old one. This old tool, like several tools from these customers, is in maintenance at TSD. During the last maintenance it turned out that this tool had to be replaced. In cooperation with the customer, we have also optimized the product.

 This follow-on cutting and bending stamp cuts and forms a pressure ring in 5 steps

Project properties

  • Tool for cutting and forming pressure rings made of 3 mm thick cold-rolled steel.
  • Tool must fit on an existing press.
  • Optimization of the product.